Box #2 "Blocks"

This project takes four Box #2's. They are put together normally but I added a piece of card stock to fit the bottom of the box so all sides would be smooth.

You could spell out anything in this manner.

See blog post for this project here.

Box #2 Circus Box

This project takes one Box #2 , plus one extra "lid/flap" from the die. Adhere second lid-flap to front of box (adhering on the top inside edge), bring both lids up to a gable. On this one I decorated it as a circus tent and added jumbo clips to pull ribbon through to close.

See blog post for this project here.

Box #2 Gable Roof

This project takes one Box #2 , plus one extra "lid/flap" from the die. When running through the 2nd lid/flap from the die, just make your cardstock a little longer than the flap (approx. 1/4 inch). On that extra 1/4 inch edge of cardstock, place Sticky Strip and adhere to the front top inside edge of the box to make the front match the back. The lids will then pull up into a gable top.

See blog post for this project here.

Box #2 Tote (2 Section)

This project takes two Box #2 Totes, leaving the flaps on and straight up. I punched a hole in mine. Put together back to back with sticky strip and decorate. Holds goodies for a great gift.

See blog post for this project here.

Box #2 Business Card/Treat Holder

Just leave the flap up on the Box #2 die, punch out a scoop in the front and decorate. I used the Wide Oval Punch on this. Easily fits business cards or a cello bag of goodies.

See blog post for this project here.

Box #2 "Purses"

For this project I added a little extra to the flap where it creases and put it on the outside of the box. I then embellished, added handles, and decorated the box to make it look like a purse.

See blog post for this project here.

Box #2 Stamped

This is basically the regular box made as the die was intended. I stamped on the box directly. These boxes are a great size.

See blog post for this project here.

Box #2 With Window

For this project, cut out the front with the Curly Label Punch (cutting twice) and added Acetate (Window Sheets).

See blog post for this project here.